PRODUCT APPLICATION

Ensure surfaces are clean, dry, and free from oils, traffic film, greases, tars etc. Wipe over the surface with TEK038 Universal Degreaser, to remove any tar or asphalt deposits, and allow to dry. Mask the area to prevent overspray. Undertake a small test application on an inconspicuous area prior to use to ensure suitability for use.

Shake the can thoroughly for at least two minutes. Repeat shaking at regular intervals during use.

Spray from a distance of 20 to 30cm. Thinly applied coats built up at 10-15 minute intervals will achieve the best result.

Allow at least 24 hrs between applying final coating and any over-painting that may be required. After use invert can and spray to clear nozzle.

Where to use:
Lower body panels including sills and valances.

Where not to use:
This product is a specific rubberised coating, and should be used only for the intended application.