PRODUCT APPLICATION

Prepare the primed area to be treated, ensuring freedom from dust, grime, greases, oils etc, with TEK038 Universal Degreaser or suitable alternative and allow to dry.

If necessary, the surface may be flattened by abrading the surface lightly, using 1200 grade wet and dry abrasive paper, and solvent treated as described above to remove any dust.

Shake the can thoroughly for at least two minutes. Repeat shaking at regular intervals during use.

Apply sparingly from a distance of 20 – 25cm. Apply typically 2 to 3 light coats as necessary to achieve total and even coverage, leaving 10 – 15 minutes between each application.

Allow to fully harden for at least 24 hours.

On completion of use, invert can and depress actuator for a few seconds to prevent nozzle blockage.

Where to use:
All types of metallic and rigid plastics surfaces when used in conjunction with the appropriate primers.

Where not to use:
Surfaces treated with primers of unknown composition, without first ascertaining suitability of use